REGULATIONS - Four pillars of International Maritime Law.


REGULATIONS - Four pillars of International Maritime Law.



SOLAS

MARPOL

MLC

STCW

STEERING GEAR SOLAS REQUIRMENTS

SOLAS REGULATIONS II-1 PART-C REGULATIONS 28 AND 29
  • It should be able to operate from 35°on either side to 30° on the other side in within 28 seconds
  • For auxiliary steering gear - It should be able to operate from 15°on either side to 15° on the other side in within 60 seconds
  • Should restart automatically without time delay after power failure recovered
  • Provide audio and visual alarm when power failure
  • Short circuit protection only for control circuit
  • One motor should be connected with ESB
  • Control shall be provided in SG room and BRIDGE
  • Means of communication should be provided in SG and BRIDGE
  • Rudder angle indicator should provide in SG and BRIDGE
  • Fixed storage tank for hydraulic oil
  • Low level alarm for hydraulic oil
  • Running indication should be provided in SG and BRIDGE
  • Overload alarm
  • Phase failure alarm
  • Protection against the excess current not less than twice of full load current

Read alsoFrequently asked questions and answers-steering gear systems of ships


EMERGENCY GENERATOR

EMERGENCY FIRE PUMP

REEFER CABLE REGULATION

CONTAINER REGULATION


BULK CARRIER REGULATION

LIFEBOAT REGULATION

EMERGENCY BATTERY REGULATION

GMDSS BATTERY REGULATION






We love to hear your comments on this article, so that we may better serve you in the future.

Post a Comment

3 Comments

  1. This comment has been removed by the author.

    ReplyDelete
  2. Hi Brother, Here Robinson, Very Useful Sago. Kindly correct Steering gear SOLAS Regulation Number, 29 and 30. Mistakenly here showing 28 and 29. Thanks.

    ReplyDelete
  3. You'll be taught more about the Vacuum Storage Bags program and particular admissions requirements, and get your questions answered by program college and workers. These external corners are a pure consequence of machining round that a part of} the design. Any radius will work, and external fillets will reduce sharp edges and stress accumulation on the corners. External fillets also help remove weak corners that can cause damage or scratches to different elements or customers. Premium components can typically CNC-engrave or laser-etch your half to add desired text and letterings. Relative to CNC engraving, laser etching is more cost effective|more economical|less expensive} and flexible.

    ReplyDelete

We love to hear your comments on this article, so that we may better serve you in the future.